Mechanical compaction and ultrasonic velocity of sands with different texture and mineralogical composition

This study presents the results of experimental compaction while measuring ultrasonic velocities of sands with different grain size, shape, sorting and mineralogy. Uniaxial mechanical compaction tests up to a maximum of 50 MPa effective stress were performed on 29 dry sand aggregates derived from eight different sands to measure the rock properties. A good agreement was found between the Gassmann saturated bulk moduli of dry and brine saturated tests of selected sands. Sand samples with poor sorting showed low initial porosity while sands with high grain angularity had high initial porosity. The sand compaction tests showed that at a given stress well-sorted, coarse-grained sands were more compressible and had higher velocities (Vp andVs) than fine-grained sands when the mineralogy was similar. This can be attributed to grain crushing, where coarser grains lead to high compressibility and large grain-to-grain contact areas result in high velocities. At medium to high stresses the angular coarse to medium grained sands (both sorted sands and un-sorted whole sands) showed high compaction and velocities (Vp andVs). The small grain-to-grain contact areas promote higher deformation at grain contacts, more crushing and increased porosity loss resulting in high velocities. Compaction and velocities (Vp andVs) increased with decreasing sorting in sands. However, at the same porosity, the velocities in whole sands were slightly lower than in the well-sorted sands indicating the presence of loose smaller grains in-between the framework grains. Quartz-poor sands (containing less than 55% quartz) showed higher velocities (Vp andVs) compared to that of quartz-rich sands. This could be the result of sintering and enlargement of grain contacts of ductile mineral grains in the quartz-poor sands increasing the effective bulk and shear stiffness. Tests both from wet measurements and Gassmann brine substitution showed a decreasingVp/Vs ratio with increasing effective stress. The quartz-rich sands separated out towards the higher side of theVp/Vs range. The Gassmann brine substitutedVp andVs plotted against effective stress provide a measure of the expected velocity range to be found in these and similar sands during mechanical compaction. Deviations of actual well log data from experimental data may indicate uplift, the presence of hydrocarbon, overpressure and/or cementation. Data from this study may help to model velocity-depth trends and to improve the characterization of reservoir sands from well log data in a low temperature (<80-100^o C) zone where compaction of sands is mostly mechanical.