Abstract
Alkali-activated binders (AABs) have been and continue to be extensively explored as an alternative to ordinary Portland cement (OPC), addressing environmental and sustainability issues. A large number of studies that were conducted earlier focused mainly on the mechanical properties and some durability aspects of industrial waste-based AABs. However, chloride migration and diffusion causing reinforcement corrosion in AAB-based concrete (AAC) have not been thoroughly investigated. The present study focuses on the durability of AAC produced using multiple precursors that included industrial waste materials and natural minerals such as limestone powder (LSP), red mud (RM), silicomanganese fume (SMF), and natural pozzolan (NP) activated by alkali. Firstly, the dosages of all four precursors were optimized through trials and then NP was partially replaced by 10, 20 and 30% OPC to enhance the performance of the AABs. The AAC mixtures were prepared and cured under different conditions and tested for compressive strength and durability characteristics related to chloride permeability, chloride migration, chloride diffusion, and chloride-induced reinforcement corrosion to evaluate the performances of the mixtures. The results show that the composition of the AABs and curing regimes significantly influenced the performance of the AAC. The inclusion of the OPC resulted in a very significant enhancement of the strength and durability characteristics of the AAC. In addition, there is a sharp increase in the performance of the AAC mixtures when the OPC content of the precursor was increased from 10 to 20%, irrespective of the curing method. Therefore, an optimum dosage of the OPC in the precursor can be considered as 20%, allowing utilization of 80% waste materials and natural minerals as the precursor with much higher strength and durability characteristics than traditional OPC concrete, thus saving energy and reducing environmental pollution leading to a cleaner production of concrete. Lastly, electrochemically measured corrosion potential (Ecorr) and corrosion current density (Icorr) values for the reinforcing bars (rebars) embedded in AAC mixtures were found to be misleading, as confirmed by visual inspection of the extracted rebars in addition to gravimetric test results. Hence, there is a need for further research to develop corrective measures before the utilization of the electrochemical-reinforced corrosion monitoring methods in the case of AACs.
Original language | English |
---|---|
Pages (from-to) | 1483-1501 |
Number of pages | 19 |
Journal | Journal of Sustainable Cement-Based Materials |
Volume | 13 |
Issue number | 10 |
DOIs | |
State | Published - 2024 |
Bibliographical note
Publisher Copyright:© 2024 King Fahd University of Petroleum & Minerals, Saudi Arabia. Published by Informa UK Limited, trading as Taylor & Francis Group.
Keywords
- Natural minerals
- alkali-activated binders
- cement
- chloride-induced reinforcement corrosion
- concrete
- durability
- industrial waste materials
ASJC Scopus subject areas
- Ceramics and Composites
- Waste Management and Disposal