Decolorization of multicomponent dye-laden wastewater by modified waste fly ash: a parametric analysis for an anionic and cationic combination of dyes

In this research study, waste fly ash (WFA) underwent acid activation and subsequent amine functionalization using ammonia solution. This treatment improves the porosity, thermal tendency and crystallinity of WFA. Modified WFA was tested under different experimental conditions to treat the wastewater consisting of different concentrations of cationic (methylene blue and rhodamine 6G) and anionic (methyl orange) dyes. As an individual, methylene blue (MB) and rhodamine 6G (Rh) showed ~ 100% and ~ 82% removal efficiencies respectively in an alkaline medium while methyl orange (MO) exhibited only ~ 20% adsorption in the same medium. An antagonistic effect was observed in adsorption when wastewater contains both cationic dyes whereas the combination of cationic and anionic dyes in solution manifested a synergistic effect. For all individual and binary dye combinations, there is a close agreement in observed and calculated uptakes when the data was fitted to the fractional order kinetic rate equation. The adsorption of all dyes is spontaneous and endothermic in nature except for MB/MO combination where the process is exothermic in nature. 24.93 mg/g, 24.83 mg/g, and 14.95 mg/g monolayer uptake capacities of MB, Rh, and MO were found respectively from isothermal analysis of single dye adsorption data. Further, extended sips model gave higher correlation coefficient (R ² = 0.99) and addressed the failed assumptions of both the Langmuir and Freundlich models. Overall, in the experimental results, the modified waste fly ash could act as successful adsorbent to treat dye bearing wastewater. Graphical Abstract: [Figure not available: see fulltext.].